Filter
Top Products
35
English
Radio Reception
Tuning to radio stations
1 Press STANDBY-ON B (B on the remote
control) to switch on the last selected source.
2 Press SOURCE (TUNER on the remote
control) to select TUNER mode.
3 Press and hold ¡ / ™ (1 / 2 on the remote
control) until the frequency indication starts to
change, then release.
➜ The system automatically tunes to the next
strong radio station.
● To tune to a weak station, press ¡ / ™ (1 / 2
on the remote control) briefly and repeatedly
until an optimal reception is found.
4 Repeat Step 3 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 20 stations regardless of
the reception.
Automatic progamming
● Press PROGRAM on the remote control for
more than two seconds to activate
programming.
➜ All available stations are programmed.
Manual progamming
1 Tune to your desired radio station (refer to
“Tuning to radio stations”).
2 Press PROGRAM on the remote control.
➜ ”PROG” icon flashes.
3 Press PRESET+/- (or ¡ / ™ on the remote) to
select the desired preset number.
➜ If “PROG” icon goes off before you select the
desired preset number, press PROGRAM on
the remote control.
4 Press PROGRAM on the remote again to
store the radio station.
● Repeat steps 1-4 to store other radio stations.
Other Functions
Listening to preset radio stations
● In tuner mode, press PRESET+/- (or ¡ / ™ on
the remote control) to select the desired preset
number.
➜ The preset number, radio frequency, and
waveband are displayed.
Setting the clock
1 In Standby mode, press and hold CLOCK on
the remote until the time flashes on the display.
➜ ”CLOCK SET” is displayed briefly. Then, the
hour digits flash on the display screen.
2 Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
hours.
3 Press CLOCK to confirm.
➜ The minute digits flash on the display screen.
4 Turn VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
minutes.
5 Press CLOCK again to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the
system is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
pg 023-041_MCD728_93_Eng 2007.7.31, 17:1535