Filter
Top Products
User Manual BDS4223V
46
7.6 SYSTEM PASS CODE
Setting System Pass code
The system pass code setting is used in conjunction with V-Chip
(Parental Guide) and Channel Lock functions. The same security
passcode is used for both functionality. By default, this monitor is
shipped with the security pass code set at 0000.
1 Press the MENU on the monitor panel or remote control.
2 Use the SEL or SEL key to select the SETUP option from the
menu.
3 Press the ADJ key to confirm the selection.
=> Various options are available in the SETUP menu.
4 Use the SEL or SEL key to select the PASS CODE option.
5 Press the ADJ
key to confirm selection.
=> The ENTER PASS CODE window appears.
6 Use the number keys on the remote control to enter the currently
used pass code. As each numeric digit is entered, a small "X" fills
each slot.
● If the code has not been set before, please use the default "0000"
code.
● If the code entered is incorrect, an "Error" status is displayed.
Simply enter the pass code again.
Notes:
● When entering the 4-digit pass code, please enter the digits
slowly. The monitor will display "X" in each of the number slots
as it receives the pass code.
● If the wrong passcode is entered three times, the monitor will go
back to the SETUP menu. Repeat the above procedure to reset
your pass code.
7 When the currently used passcode is entered correctly, the monitor
will prompt to enter of a new passcode. Enter the four digit
passcode using the numeric keypad on the remote control.
8 Re-enter the new passcode one more time to confirm.
Note:
Please contact authorized customer service center if you did forget the
pass code.
ENTER PASS CODE
INCORRECT!!