Filter
Top Products
1 Plug the female end of the power cable supplied into the
Power connector on the rear of the player.
2 Plug the male end of the cord into an AC outlet.
- When the player is in the “OFF” position, it is still consu-
ming some power. If you wish to disconnect your player
completely from the mains, withdraw the plug from the AC
Outlet.
Caution
Only qualified service personnel should remove the
cover or attempt to service this device.
LOADING THE BATTERIES
1 Open the battery compartment cover.
2 Insert two 'AAA' (R03) batteries as indicated inside the
battery compartment.
3 Close the cover.
Caution
Do not mix old and new batteries. AND never mix diffe-
rent types of batteries (standard, alkaline and so on).
NOTE
- Unless otherwise mentioned, all operations can be carried
out with the remote control. Always point the remote con-
trol directly at the player, making sure there are no obstruc-
tions in the path of the infrared beam.
- When there are corresponding keys on the front panel, they
can also be used.
1 Switch on the TV and select the video input for your DVD-
Video player.
2 To enjoy sound through your stereo system, turn on the
system and select the source input for the DVD-Video
player.
OR
To enjoy DVD-Video with multichannel (surround) sound,
switch on the Home Cinema system and select the source
input for your DVD-Video player.
3 On the front of the DVD-Video player, press Power
ON/OFF. The player display lights, and the OSD invites
you to load a disc.
4 With Autoplay ON (the factory setting) any disc already
loaded in the player starts to play.
You can switch the NTSC/PAL setting of the DVD player to
match the video signal of your TV. This setting only affects
the television’s on-screen display that shows the stop and
setup modes. You may select either NTSC or PAL. To change
the DVD player setting to PAL or NTSC, follow the step below.
1 Press POWER ON/OFF button on the front panel of the
DVD player to turn OFF the DVD player.
2 Press and hold / and
P on the front of the DVD player.
While holding / and P, press POWER ON/OFF to turn
ON the DVD player.
3 After PAL or NTSC appears on the display panel of the
DVD player, release / and P at the same time. The PAL
or NTSC that appears on the display panel indicates the
current setting.
4 To change the setting, press P within 3 seconds. The
new setting (PAL or NTSC) will appear on the display
panel.
NTSC/PAL SETTING
inse
SWITCHING ON
OPERATION
INFRA RED REMOTE CONTROL
CONNECTING THE POWER SUPPLY
ee nn ggll ii ss hh
13
STANDARD CONNECTIONS GETTING STARTED