Filter
Top Products
Important notes for users in the UK
This set complies with the radio interference requirements of the
European Union.
Mains plug
This apparatus is fitted with an approved 13 Amp plug.To change a fuse in this
type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 5Amp,A.S.T.A.or BSI approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets,it should be cut off and an
appropriate plug fitted in its place.If the mains plug contains a fuse, this should
have a value of 5 Amp.If a plug without a fuse is used, the fuse at the
distribution board should not be greater than 5 Amp.
Note:The severed plug must be disposed of to avoid a possible shock hazard
should it be
inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following code:blue = neutral
(N),brown = live (L).As these colours may not correspond with the colour
markings identifying the terminals in your plug, proceed as follows:
• Connect the blue wire to the terminal marked N or coloured black.
• Connect the brown wire to the terminal marked L or coloured red.
• Do not connect either wire to the earth terminal in the plug, marked E (or e)
or coloured green (or green and yellow).
• Before replacing the plug cover,make certain that the cord grip is clamped
over the sheath of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent.See Copyright Act
1956 and The Performer’s Protection Acts 1958 to 1972.
CAUTION!
Apparatus shall not be exposed to dripping or splashing. Do not place any
sources of danger on the appartus (e.g. liquid filled objects,lighted candles)
PET710_ENG.QXD 2/3/05 10:05 Page 2