Filter
Top Products
3 Enter 9, 9 and 4, using the number keys.
4 Enter the 3-digit code you received from the helpline
using the number keys, within 30 seconds.
5 Press the key under which you want to store the new
function. The LED flashes twice to indicate a succesfull
installation.
If you want to store the function under a Shift/Key
combination; first press Shift, then press the required
function key.
N
OTE
- The original function of the key will be overwritten. If you
want to return to its original function see the following section
about resetting.
- Remember: no functions can be performed by this remote
control that are not present on the equipment you are
operating!
Reset your remote control to its original
presets:
If you want to return to the original functions of all keys and
delete all added functions under programmed keys a simple
reset procedure is sufficient:
1 Pres
s and hold keys 1 and 6 simultaneously - for about
three seconds - until the green LED lights up.
2 Enter 9, 8 and 1, using the number keys.
-
The LED flashes twice to indicate a succesfull reset.
The keys on your remote control will now perform their
default functions.
TROUBLESHOOTING GUIDE
• Problem:
– Solution:
• Device is not responding and the green light does not flash
when you press a button.
– Replace batteries with two new 1.5 volt, type RO3, UM4 or
AAA batteries.
• Device is not responding, but the green light does flash when
you press a button.
– Aim the SBC RU520 at the device and be sure that there are
no obstructions between the SBC RU520 and the device.
• The SBC RU520 is not performing commands properly.
– You may be using the wrong code. Try repeating Set up using
another code, listed under your brand, or start the Autosearch
Set-up over again to locate the proper code.
If the device still doesn’t respond, call the help-line and we’ll
put you back on track.
• You can’t access teletext pages and you were used to use this
(fi) button to access teletext.
– Follow Set up procedure and at step 5 of section “Your
equipment is of another brand, or your equipment is a Philips
brand, but not all keys respond correctly” press keys
0, 0, 6 and 4.
To enter teletext pages, press the teletext cancel button.
Instructions for use
6
English
9-0
9 9 4
SHIFT
1 6
0
0
6
4
9 8 1
XP SBC RU 520/00 31-05-2001 16:09 Pagina 6