Filter
Top Products
10
EN
Troubleshooting
Problem Tip
Interference on
the image of TV2.
• Slightly change the position of the
receiver or the transmitter.
• Change the wireless channel that
is used for communication. See
page 7.
• The receiver (B) is out of range of
the transmitter (A). The number
of walls and ceilings in between
the receiver (B) and transmitter
(A) restrict the distance.
The video sources
do not respond to
the remote con-
trol commands
from TV2.
• Point the remote control directly
to the receiver.
• Replace the batteries of the
remote controls with new ones.
• Install the remote control blaster
cord (F). See page 6.
• The maximum operating distance
of the remote control is 5 m.
The television
program disap-
pears on TV2.
• Turn off the auto standby mode
of the video source. See its user
manual.
• Follow the instructions to recon-
nect the video sources. See the
quick start guide.
Buzzing sound
when you use the
remote control.
• Slightly change the position of the
receiver or the transmitter until
the buzzing sound stops.
• Sometimes it is not possible to
solve the problem.
Easylink feature
does not work.
• Check if the TV and VCR support
Easylink.
• Check if you used full-wired
SCART cables.
Black and white
image with S-VHS
VCR.
• Check if the SCART connector of
the S-VHS VCR gives signal in
CVBS. See its user manual.