Filter
Top Products
6
EN
Installation
Install the remote control blaster cord
1 Switch off the transmitter (A).
2 Connect the remote control blaster cord (F) to the
IR socket.
3 Position the blaster light in front of the IR sensor of
the video source.
4 Switch on the transmitter (A).
5 Take the remote control of a video source with you.
6 Go to TV2.
7 Switch on TV2.
8 Switch on the receiver (B).
9 Select the correct SCART input on TV2.
10 Operate the video source with its remote control.
11 If necessary, repeat the steps 3 to 10 for the other
video source.
For basic installation, see
the quick start guide that
came with your Wireless
TV Link.
See the user manual of the video source
for the exact location of the IR sensor
on the front panel.