Filter
Top Products
12 Getting started
Note: If the VCR or DVD recorder
records a television program, you watch
the recorded channel.
Note: how to watch a video source on
TV1?
Use your TV1 and your video source as
usual to watch a video source on TV1.
Note: In case the video source does not
react the IR control blaster might not be
installed properly. See the FAQ “How
can I find the IR sensor on the video
source?” for locating the IR sensor on the
front panel of the video source.
3.5 Select Source
Switch between the two video source
images by pushing the source switch on
the Transmitter.
3.6 Remove interference on TV2
Depending on your specific situation,
after completing 3.1 and 3.3, you may
experience some interference.
1. Find the CHANNEL switch on the
transmitter (A). There are 4
channels. You may have to change
the channels in case of interferences.
2. Set the CHANNEL switch to a
different number on the transmitter
(A) in case of interferences.
3. Find the CHANNEL switch on the
receiver (B).
4. Set the CHANNEL switch to the
same number as on the transmitter
(A).
3.7 Improve the quality of the
reception with the antenna
1. Adjust the orientation of the
antenna of the receiver for best
picture.
2. Best transmission performance you
obtain when the front sides of the
transmitter and receiver antennas
are "faced" to each other in an
imaginable straight line.