Filter
Top Products
6 EN
English
7EN
Using the universal remote control
3 Keep buttons
and
pressed
simultaneously for 5
seconds.
• The red Setup
light lights
up. The remote control is now in setup
mode.
4
Press and hold the button that does not
function and immediately release it when
the device responds.
• If the button still does not function as
expected, try pressing it again for a longer
period of time.
5 Press the
device selection
button twice to save
your settings and
exit setup mode.
• When no
button is pressed for 5 minutes or more,
the remote control will exit setup mode,
automatically saving all your settings.
3 Using the universal
remote control
3.1 Buttons and functions
The illustration on page 8 gives an overview of
all buttons on the remote control. Try out the
buttons you need for operating your devices.
Notes
• Buttons having the same functions as the
buttons on your original remote control
may have different namings on the
SRP1103 (e.g. Info / Display).
• Only functions that are available on your
original remote control can be used for
operating your devices with the SRP1103.
2.2.2 Improving buttons
When correctly set up, the remote control
should be able to operate all your devices.
However, when using the remote control for the
first time it might occur that some buttons do
not yet function as expected.
In this case you can have the remote control
search for alternatives.
Note
Improving buttons is not possible when the
code was found during full database search
(with code ‘9, 9, 9, 9’).
During initial setup
1 Make sure the receiving device is able to
respond. E.g. when you try to repair the Play
button for your DVD player, make sure to
insert a DVD into the DVD player otherwise
the Play button is not able to function.
2 Press the button that does not function,
keep it pressed and immediately release it
when the device responds. Repeat this for
every button that does not function.
• If the button still does not function as
expected, try pressing it again for a longer
period of time.
After initial setup
1 Make sure the receiving device is able to
respond.
E.g. when you try to repair the Play button
for your DVD player, make sure to insert a
DVD into the DVD player otherwise the
Play button is not able to function.
2 Select the device
that you wish to
operate
(e.g. DVD).
Press the
device selection
button to select
DVD.
5 sec.
2 x