Filter
Top Products
Learn a key
IIf you miss certain functions from your original remote control of the
SRU 5060, the SRU 5060 can learn these functions from the original remote
control.You can store a fuction under any of the available keys of the
SRU 5060, except LEARN,SELECT and SHIFT. Please, note that any function
already stored under a key will be deleted.
Example for VCR:
Make sure you have the original VCR remote control at hand.
1 Select the device mode VCR,with the
SELECT key.
2 Press the LEARN key and the target key on
the SRU 5060 simultaneously for 5 seconds,
until VCR in the selector window blinks twice
and then remains lit.
3 Place both remote controls on a flat surface
(like a coffee table) and aim them head-to-
head with about 5 - 10 cm in between.
4 Press the button you want to copy on the original remote control.
– If the SRU 5060 has learned the code,VCR in the selector window
blinks twice to confirm the signal is stored.
– If VCR blinks once for a longer period, the IR signal is not learned by the
SRU 5060. Please, try a few times and make sure the remote controls
are aligned as described in step 3.
If the SRU 5060 cannot learn the code after several times trying,
it is possible that:
– The IR signal of your original device is out of range (the SRU 5060 can
only learn IR signals with a carrier signal of 30-60kHz.
– The memory of the SRU 5060 is full.
– The SRU 5060 stopped the learning process after 20 seconds if no
IR signals are found. Check if your original remote control is working
correctly.
Restoring the original functions of your remote
control
1 Keep keys 1 and 6 on the SRU 5060
pressed simultaneously for three seconds,
until until one of the device indicators (TV,
DVD, STB,VCR, CD,AMP) lights up window.
10
Instructions for use
English