Filter
Top Products
32
SETTING THE REMOTE CONTROL TO WORK WITH OTHER DEVICES
SLEEP
POWER
A/CH
STATUS/EXIT
CC
CLOCK
TV
VCR
ACC
RECORD
TV/VCR
SMART
PICTURE
VOL CH
MUTE
MENU
SURF
SMART
SOUND
SOURCE
SWAP
POSITION
FREEZE
PIP ON/OFF
POWER
SLEEP
A/CH STATUS/EXIT CC CLOCK
RECORD
TV
VCR
ACC
SMART
SMARTSMART
SOUND
PICTURE
MENU SURF
VOL
CH
MUTE
1
2 3
4
5
6
7
8 9
0
TV/VCR
SWAP
SOURCE POSITION FREEZE
PIP ON/OFF
1
5
2
3
4
N
ow that you have looked up
the three-digit Remote Code
Number for your brand of device,
you are ready to follow the four
simple steps below.
Please read through steps 1-4
before beginning.
Place the TV/VCR/ACC
Mode Switch in the proper posi-
tion.
Press the VCR RECORD
button on the remote control and
release.
Press the SmartSound button
on the remote within 30 seconds,
then release.
Enter the THREE-DIGIT
REMOTE CODE NUMBER
for your desired device. The
remote is now ready to send
commands to the unit.
Point the remote at the
Device. Press the POWER button
on the remote to turn the unit
ON.
Cable Converter
SMART HELP
Remember, if this doesn’t
work the first time, repeat steps
using the same remote code number.
After a second try and the remote
does not operate your device, see if
there is another three-digit code num-
ber (pages 34-35) listed for your
device and repeat the steps above
using the new number.
If after repeated attempts the code
number method does not work you
device, try the SEARCH METHOD
on page 33.
BEGIN
Satellite Receiver
or DBS, etc.
VCR
Direct Access Method