Filter
Top Products
37
75Ω
L
AUDIO
R
outin-2in-1
VIDEO
S-VIDEO
75Ω
L
AUDIO
R
MONITOR
OUT
AV1AV2
VIDEO
S-VIDEO
3
1
ANTENNA
OUT
ANTENNA
IN
VIDEO AUDIO
IN
IN
OUT OUT
1
R
L
1
2
USING THE PIP (PICTURE-IN-PICTURE) FEATURE
Picture-In-Picture (PIP) is the show-
ing of two pictures on the TV screen
at the same time. (One main screen
picture and one small inset picture -
or PIP).
Please Note: A VCR (or Accessory
Device) is needed to supply the PIP
signal.
The follow steps describe the basic
hookup needed to use PIP:
First use an optional signal
splitter and connect the original
cable TV signal to both the
CABLE/ANT IN on the VCR and
the 75Ω input jack on the rear of the
television.
Connect the VIDEO OUT jack
on the VCR to the VIDEO AV1
jack on the TV.
Connect the AUDIO OUT
(right and left) jacks from the
VCR to the AUDIO AV1 (right and
left) jacks on the television.
Be sure to turn the VCR ON while
using the PIP features. The signal
supplied through the VCR will
appear in the PIP window once the
PIP Source has been selected.
Please refer to the next page to learn
ho to set the PIP Source control.
SMART HELP
For other possible PIP
connections see pages 41-42
for the “More PIP Connections”
section.
If you need any accessories or parts
to complete the described PIP con-
nections, contact your dealer, or our
Parts Information Center at:
1-800-851-8885
BEGIN
Hooking up PIP
BACK OF TV
OPTIONAL TWO-WAY SIGNAL
(single 75 ohm Input to twin 75
ohm Outputs - optional RF
Coaxial connecting cables also
required)
ROUND CABLE 75 OHM
ROUND CABLE
75 OHM
AUDIO IN
(RED/WHITE)
VIDEO IN
(YELLOW)
BACK OF VCR
VCR WITH AUDIO/VIDEO OUPUTS