Filter
Top Products
Timer Recording with the VCR Plus+ Programming System (cont’d) 41
• If the preset time for a timer record-
ing comes up during an OTR, the
OTR has priority. A message will
remind you when the timer recording
was scheduled to begin. You may let
the OTR continue; the timer recording
will not take place. Or, stop the OTR
and turn off the VCR immediately.
The timer recording will take place if
you turn off the VCR before the timer
recording’s scheduled start time.
• To stop a started timer recording,
press the STOP/EJECT button on the
VCR.
• If the power fails for more than one
minute, programmed timer recordings
may be lost. Reset the clock before
resetting the timer recordings.
• If you are using a Cable Box/DBS,
timer recordings are programmed dif-
ferently. See pages eight and 38-39
for details.
See page 52 for more hints.
Helpful Hints
5
Press the Number 1 button to record in SP speed or the
Number 2 button to record in SLP speed. Your selection
will appear beside REC SPEED on the screen; SP=1 SLP=2 will
continue to flash. For details about tape speed, see pages 36 and
54. You cannot use the SPEED button at this time.
6
Press the STATUS/EXIT button. PROGRAM WAS COM-
PLETED / PLEASE TURN OFF VCR FOR TIMER RECORDING
should appear on the screen briefly.
7
Press the POWER button to turn off the VCR power. The
Timer light will appear. The Timer light will flash if there is not a
tape in the VCR.
If the timer recording will take place several hours or days from
now, you may use the VCR until time for the recording. Just turn
off the VCR a few minutes before the recording starts. If you for-
get to turn off the VCR, PLEASE TURN OFF VCR FOR TIMER
RECORDING flashes on your TV screen two minutes before a
timer recording starts. Remove the message by pressing the
CLEAR button.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 09
TIME ON 10:30 PM
TIME OFF 11:30 PM
REC SPEED SLP
SP=1 SLP=2
START DATE 10/10/99
SUN.
TO END PUSH EXIT
5
6
7
Turn off the VCR
for the recording.
Insert a tape in the VCR.
Leave the Cable Box/DBS on
(if applicable).