8 HookupsWithaCableBox
J• oleo aeo oeo oee • •co oeIo• •ee• ••• •eoo• e•e• •ell• eeo• oeoeloo• Go •••• ••• e• •o•• • • •• ••o •am a•• i•e •l• •• o• •
e•e I•ee• ••ea ••
This connection allows you to view any channel. After you connect the Cable Box, VCR, a-_
TV as shown below, the features described on this page will be available.
I. Connect Cable signalto
IN Jackon Cable Box.
f
2. Use RF coaxial cable (supplied) to
connect OUT Jack on Cable Box to
ANT(enna) IN Jack on VCR.
3.Use a second RF
coaxialcableto con-
nect the OUT jack on
theVCR to theTV's
ANTENNA IN Jack.
ANTENNA IN Jack
Back of TV
(example only)
Recording and Viewing a Scrambled or
Unscrambled Channel
I
With theVCR on and inVCR position (theVCR light will appear
on the display panel),use the CHANNEL (UplDown) buttons
to set theVCR to the Cable Box output channel (channel
3 or 4).
2
Set the TV to the same channel to which you set the VCR.
3
Select the channel you want to watch or record at the
Cable Box.
Watching TV With the VCR Off
I
Use the TV channel selector to set the TV to the Cable Box
output channel (channel 3 or 4).
2
Select the channel you want to watch at the Cable Box.
Timer Recordings
With this connection, you may set a timer recording as described
on pages 28-3 I. However, you must remember the followin_.
• You can only program a timer recording for one channel at a
time.
• Set the TV and the VCR to the Cable Box output channel
(channel 3 or 4).
• When you are prompted to enter the channel you want to
record, select channel 3 or 4 (the Cable Box output channel).
(This is step 5 on page 29.)
• Set your Cable Box to the channel you want to record.
• Leave the Cable Box on while you are recording.
• With this hookup, channels cannot
be changed using theVCR remote
controLYoumust select channels at
the Cable Box.
• You can not view a "channel other
than the one you are recording (the
instructions on page 26 do not work
with this hookup).
• You cannot program channels with
this hookup (as discussed on page
12).