Filter
Top Products
4
Real Time Counter Memory 41
• The MEMORY button does not func-
tion if Repeat Play is set to ON. To
turn Repeat Play OFF, see Helpful
Hints on page 39.
• To erase a Real Time Counter
Memory, press the MEMORY button
until the M disappears from the
screen.
• You may only set the real time
counter to zero at one location at a
time. If you try to set the real time
counter to zero at a second location,
the previous real time counter to zero
setting will be erased.
Helpful Hints
STOP 1:08 PM
TV STEREO CH10
SLP 1 : 23 : 45 HIFI
Real Time Counter Memory
Follow the steps below to reset the real time counter to zero at a
tape location you want to refer to later.
1
Play, fast forward, or rewind a tape to the location that
you would like to refer to later. Press the STOP button
on the remote control or the STOP/EJECT button on the
VCR to stop the tape.
2
Press the STATUS/EXIT button. The status display will
appear on-screen for about five seconds.
3
While the status display is still on-screen, press the CLEAR
button to reset the real time counter to zero.
STOP 1:08 PM
TV STEREO CH10
SLP 0 : 00 : 00 HIFI
4
While the counter is still on-screen, press the MEMORY button
so that M appears to the left of the real time counter on-screen.
STOP 1:08 PM
TV STEREO CH10
SLP M 0 : 00 : 00 HIFI
5
To go to a tape location where the real time counter was
reset to zero, press the REW(ind) button or the F.FWD
(Fast Forward) button when tape playback is stopped.
When the tape reaches the point at which the real time counter
was reset to zero, the tape will stop. Press the PLAY button
to watch the tape.
3
1
2
5
REW
PLAY
POWER
VCR PLUS+
/ENTER
SPEED
VCR
TIME SEARCH
TV
MUTE
CABLE
/DSS
VCR/TV
CHANNEL
VOLUME
REC/OTR
STATUS/EXIT
MEMORY
SLOW
PAUSE/STILL
MENU
CLEAR
EJECT
STOP
F.FWD
– +
1
2 3
4
5 6
7
8 9
0
+100