Filter
Top Products
1
Make the connections shown above.
38 Rerecording (Tape Duplication)
3
VCR 2 will record your tape. Insert a blank tape in VCR 2. The
VCR must be in VCR position. (The VCR light will appear on the display
panel. If it does not, press the VCR/TV button once.)
4
Turn on the TV and set it to channel 03 or 04, whichever
channel the CH3/CH4 switch on VCR 2 is set to.
5
Point the remote control at VCR 2. Press Number but-
tons 0, 0, 1 or 0, 0, 2. (See Helpful Hints at right.)
6
Use the SPEED button to select SP, LP, or SLP at VCR 2.
7
Press the PLAY button on VCR 1 and the REC(ord)/OTR
button on VCR 2 at the same time.
To stop recording, press the STOP/EJECT button on VCR 1, then
press the STOP/EJECT button on VCR 2.
R
L
VIDEO
IN
OUT
IN
OUT
AUDIO
R
L
VIDEO
IN
OUT
IN
OUT
AUDIO
CH3
CH4
OUT
IN
ANT
CH3
CH4
OUT
IN
ANT
VCR 1
Playing VCR
VCR 2 - Recording VCR
2
VCR 1 will play your tape. Put a prerecorded tape in VCR 1.
1. Audio cables from AUDIO OUT Jacks of VCR 1 to
AUDIO IN Jacks of VCR 2
2. Video cable from VIDEO OUT Jack
of VCR 1 to VIDEO IN Jack of VCR 2
3. RF coaxial
cable from VCR’s
OUT Jack to TV’s
ANTENNA IN
Jack
• If you use the AUDIO and VIDEO
IN Jacks on the back of VCR 2,
press Number buttons 0, 0, 1. AV
REAR will appear on-screen.
• If you use the AUDIO and VIDEO
IN Jacks on the front of VCR 2,
press Number buttons 0, 0, 2. AV
FRONT will appear on-screen.
• Unauthorized recording of copy-
righted television programs, video
tapes, or other materials may
infringe on the rights of copyright
owners and violate copyright laws.
• These instructions show you how to
copy tapes using two VCRs like
yours. Different VCRs may operate
differently.
Helpful Hints
● Audio and Video cables are not supplied.
VRZ262(H1920).QX33 4/9/99 9:33 AM Page 38