Filter
Top Products
14) SPEED SET LD (CAV Only)
Function: Speed for Multi-Speed playing is specified.
Format: Integer S P
Explanation: Contents of the Speed Register are rewritten with this command.
Immediately, the completion status is returned. The active mode
of the player does not change. This command is accepted even
when Multi-Speed Mode is in effect.
The speed parameter indicates the number of fields moved per
second, and it is specified in range from 1 to 255. It is 60 (with a
range from 45 to 90) for normal play. The initial value is 60.
The relationship between representative play speeds and
parameters is as follows:
These integers provide compatibility with LD-V8000, LD-V4400 and the
LD-V2200. Programs written for the LD-V8000 or LD-V4400 using the Òrange of
integersÓ in column two will play on the CLD-V5000, CLD-V2800/2600/2400 at
the corresponding speeds in column one.
Execution: * Play Mode
3 0 S P M F <C/R> R <C/R>
* 1/2 speed Multi-Speed play
15 S P <C/R> R <C/R>
* 1/4 speed Multi-Speed play
CLD-V5000 Level III ¥ Chapter Three
Integer Possible range Speed Integer Possible range Speed
of integers of integers
180 150-255 X3 15 12-22 1/4
120 91-149 X2 7 6-11 1/8
60 46-90 X1 4 3-5 1/16
30 23-45 1/2 2 0-2 Step 1*
Figure 3-H
CLD-V5000 Level III UserÕs Manual TP 120 v. 1.0 ¥ 1/96 3-17
* NOTE: 2SP plays one frame every second (Step 1) on the CLD-V5000, and on the
CLD-V2800/2600/2400. Similarly, 2SP sets a Step 1 to play one frame every second
on the Pioneer LD-V2200, LD-V4400 and LD-V8000. Early versions of the
CLD-V2400 played 1 frame every three seconds (Step 3) if a 0SP or 1SP were sent to
the player. Later production units of the CLD-V2400, however, all play Step 1 if a 0SP,
1SP or 2SP is sent to the player. To achieve compatibility across the player line for a
one frame per second playback speed, send the 2 SP command, followed by MF
(Multi-Speed Forward). On the CLD-V5000, STEP 3 is only available using the
Remote Control Unit.