Filter
Top Products
ON-SCREEN PROGRAMMING
Addendum to DVD-204 / DVD-212 Manual
Effective with version 2.03, most programming tasks can be
accomplished without having to connect the DVD-204 /DVD-212
to a computer. Using only a DVD-204 /DVD-212, a Pioneer
7200 /7400 DVD player, and a video monitor, it is possible
to program the DVD-204 /DVD212. Please note that only
frame numbers (not chapters) can be used when programming
on-screen. Many of the other setup options may be imple-
mented by the on-screen technique.
First, set up the DVD player, the video monitor, and the
DVD-204 /DVD212. The DVD to be used must be in the player.
Apply power to all three components. Make sure that the
DVD player and video monitor are turned on. Press the red
"Program" button on the back of the DVD-204 /DVD-212. The
monitor screen should now display the model and version
number as well as information on how to contact Museum
Technology Source. A few seconds later, the screen will
display:
At this point, pressing
button 1 on the front of the DVD-204 /DVD-212 will
instruct the DVD-204 /DVD-212 that you wish to place new
frame numbers into memory, or to determine what frame num-
bers are currently stored. Note: whenever a button can be
usefully pressed, it will be flashing: here, buttons 1
though 4 are chasing.
Note:
"PROGRAM button" refers to the red button on the
rear panel of the DVD-204 or DVD-212
1
***Main Menu***
View or Edit...
1-Button Program
2-Idle Program
3-Button 4 Reset
4-Option Menu
PROGRAM button-Exit & Run
Button Idle Reset Options
1 2 3 4