Filter
Top Products
10
<DRC1083>
En
Fig. 4
CONNECTING THE DRIVE IN THE MIDDLE OF A SCSI CHAIN
When a SCSI hard disk or other SCSI equipment also is installed in the computer,
please connect according to the following method.
¶ Switch off the power supply of the personal computer.
¶ Set the SCSI ID number so that it is different from the ID numbers of all other SCSI
units.
¶ Set the termination OFF.
¶ Connect the power supply cable from the personal computer. At the time of
connection, pay attention to the cable polarity. Please use a power supply cable
with two or more connectors in parallel.
¶ Connect the SCSI interface cable. At this time, confirm that the pin 1 of the SCSI
connector is connected correctly to pin 1 of the cable. Use a cable with two or
more connectors in parallel.
¶ When a sound board is used, connect the audio output with an audio cable to the
sound board.
WARNING
The power supply of the personal computer always must be switched
off before cables are connected.
DVD-U02
Pin 1
Pin 1
SCSI
Interface
Cable
Audio Cable
To the power supply of
the personal computer
SCSI HOST
Adapter
Sound Board
Into an expansion slot of
the personal computer
SCSI hard disk