Filter
Top Products
3
En
Information to User:
Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate
the equipment.
Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by
qualified service personnel.
[For Canadian Model]
This Class B apparatus complies with Canadian ICES-003.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiver or receiving antenna.
Increase the separation between the equipment and the receiver.
Plug the equipment into an outlet on a circuit different from the receiver.
Consult the dealer or an experienced technician for assistance.
DANGER – VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. AVOID DIRECT EXPOSURE TO
BEAM.
CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.
CAUTION: The use of optical instruments with this product will increase eye hazard.
Federal Communications Commission Declaration or Conformity
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause un-desired operation:
Product Name: External DVD / CD Writer
Model Numbers: DVR-X122
Responsible Party Name: PIONEER ELECTRONICS SERVICE INC.
Address: 1925 E. Dominguez Street, Long Beach, CA 90810 U.S.A.
Caution: This product satisfies FCC regulations when shielded cables and connectors are used to join the unit
to other equipment. To prevent electromagnetic interference with electrical appliances such as radios and
televisions, use shielded cables and connectors.
Operating Environment
Operating environment temperature and humidity:
+41ºF – +95 ºF (+5ºC – +35 ºC); less than 85% RH (cooling vents not blocked)
Do not install in the following locations:
• Exposed to high humidity or poor ventilation
IMPORTANT NOTICE – RECORD THE MODEL NUMBER AND SERIAL NUMBER OF THIS
UNIT BELOW. THE NUMBERS ARE ON THE REAR PANEL.
MODEL #: DVR-X122
SERIAL #:
KEEP THESE NUMBERS FOR FUTURE REFERENCE.
is a trademark of the DVD Format / Logo Licensing Corporation.