Filter
Top Products
7
En
INTERFACE
Front View
1) Forced Ejection Hole
If the tray fails to eject when the Eject button is pressed, insert a stiff rod into the hole and
push to eject the tray.
During normal operation, the eject button should be used to unload the tray. Turn the power
to the drive OFF then wait approximately one minute until the disc stops spinning before trying
to eject the tray using the Forced Ejection Hole.
2) BUSY Indicator
Operation status is indicated as follows:
During reading Lights
During writing Lights
3) Eject Button
Press the button to unload / load the disc.
4) Disc Tray
Press the Eject button to open the loading tray then place a CD or DVD disc onto the tray with
the label facing up. Press the Eject button again or gently push the tray to close and load.
Do not attempt to pull out the disc tray forcibly – use the Forced Ejection Hole (1).
ABOUT REGION CODES
The region code can only be changed five (5) times, including the initial setting. Please be aware
that the fifth change becomes PERMANENT. Therefore, avoid changing the region code unless
absolutely necessary.
Region codes are part of the DVD Standard. However, region codes on DVD discs are
optional. DVD discs with no specified region code can be played on all compliant players.
4
1
2
3