Filter
Top Products
5
En
English
Attaching the Pioneer Television
The weight of a 50 inch Pioneer television
(without speaker) is about 34 kg (75 lbs), they
have no depth, and are unstable. Therefore,
at least two people must assemble and install
them.
Ìi
• Be sure to install it on a flat stable location.
• Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
• Make sure that you install the support columns reliably with
reference to the procedure in “Assembling the Stand”.
Attachment Method
1
Attaching the Pioneer television to the
stand.
Fit the stand’s support columns to the bottom of the
Pioneer television as indicated by the arrows, then slowly
insert them vertically. Be extremely careful not to insert
the support columns of the stand into any part of the
Pioneer television other than the stand insertion slots.
Note that doing so might damage the Pioneer television
panel or its ports or result in the warping of the stand.
-JOFVQUIFDPMVNO
TVQQPSUTXJUIUIFCPUUPN
PGUIF1JPOFFSUFMFWJTJPO
BTJOEJDBUFEJOUIF
BDDPNQBOZJOHEJBHSBN
2
Securing the Pioneer television with
Installation screws
.
Secure them using the enclosed hexagonal wrench.
*OTUBMMBUJPOTDSFXT
.YNNTJMWFS
#AUTION
#AUTION
3
Securing the Pioneer television with
Installation screws
.
Attach the Pioneer television at the points marked with
“T” using the enclosed hexagonal wrench.
There have been cases where unforeseen
accidents such as the equipment breaking or
falling over occurred because the stand was
installed with wrong screws.
*OTUBMMBUJPOTDSFXT
.YNNCMBDL
4
Attaching the speakers.
Refer to the operating instructions for the speaker for the
installation method.
PDK-TS36B_AZR1279B.indb 5 2008/07/07 9:32:33