Filter
Top Products
6
En
Forward/Backward Angle of Inclination Adjustment Mechanism
On this stand, you can adjust the angle of inclination of the
Pioneer television within a range of approximately 2° forward
or backward according to your preference.
Ìi
• Be sure to adjust the angle only after you have
attached the Pioneer television.
• Be sure to install it on a flat table or other flat
surface.
• Be sure to hold the top of the Pioneer television
with your hand while adjusting the angle.
Adjustment Procedure
1
Loosen the forward/backward inclination
anchor bolts using the enclosed C wrench (2
locations on the left and right).
While being sure to hold the top of the Pioneer television
with your hand, loosen the
forward/backward
inclination anchor bolts
on the left and right sides by
rotating them upwards using the enclosed C wrench.
'PSXBSECBDLXBSE
JODMJOBUJPOBODIPSCPMU
-PPTFOJOH
2
Set the angle you prefer.
Set the angle you prefer by slowly moving the Pioneer
television.
Ìi
While adjusting the angle, be very careful to keep your
hands out of the place indicated by the arrow on the
figure.
3
Tighten the forward/backward inclination
anchor bolts (2 locations on the left and
right).
Firmly tighten the
forward/backward inclination
anchor bolts
on the left and right sides by rotating them
downward using the enclosed C wrench.
Be sure to hold the top of the Pioneer television with your
hand until you have fully tightened the bolts.
'PSXBSECBDLXBSE
JODMJOBUJPOBODIPSCPMU
5JHIUFOJOH
4
Check once more to make sure that the
forward/backward inclination anchor bolts
are fully tightened.
PDK-TS36B_AZR1279B.indb 6 2008/07/07 9:32:33