Filter
Top Products
53
<VRB1205>
Preparation
Basic
Operation
Setup
Other
Information
Detailed
Operation
Setup
Basic
Operation
Preparation
7 CAUTION: WHEN PLACING THE UNIT IN
A STEREO RACK WITH GLASS DOORS
Be sure there is ample space between the unit and the glass
doors when opening the disc table using the remote control. If
the disc table opens against strong resistance, such as a closed
glass door, damage to the unit may result.
7 CONDENSATION
Moisture will form in the operating section of the player if the
player is brought from cool surroundings into a warm room or if
the temperature of the room rises suddenly. When this happens,
player’s performance will be impaired.
To prevent this, let the player stand in its new surroundings for
about an hour before switching it on, or make sure that the room
temperature rises gradually.
Condensation may also form during the summer if the player is
exposed to the breeze from an air conditioner. In such cases,
change the location of the player.
7 SWITCH POWER OFF WHEN NOT USING
THE UNIT
Depending on the strength of the TV or radio broadcast signal,
having the TV or radio ON while power to the unit is ON may
result in stripes on the TV screen or noise. However, this is not a
malfunction of this unit or the TV or radio. In such a case, switch
the power of the unit OFF.
For Proper and Long Use
For Proper and Long Use
7 DO NOT MOVE THE UNIT DURING
PLAYBACK
During playback, the disc rotates at high speed. Do NOT lift or
move the unit during playback. Doing so may damage the disc.
7 WHEN MOVING THIS UNIT
When changing places of installation or packing the unit for
moving, be sure to remove the disc and return the disc table to
its original position in the player. Then, press the STANDBY/
ON and switch the power stanby.
Check that the “–OFF–”
indication on the display goes off, then disconnect the power
cord.
Moving this unit with the disc loaded may result in damage to
this unit.
7 INSTALLATION
÷ Select a stable place to the side of a TV set or stereo system
to be connected to the unit.
÷ When using the unit with a stereo system, install the speakers
a little bit away from the TV.
÷ Do NOT install the unit on top of a TV or color monitor. Install
the unit away from equipment that may be affected by
magnetism, such as a cassette deck.
7 AVOID INSTALLING IN A PLACE THAT IS:
÷ Exposed to direct sunlight
÷ Exposed to humidity or where ventilation is poor
÷ Extremely hot or cold
÷ Exposed to vibration
÷ Exposed to dust
÷ Exposed to oily smoke, steam or heat (for example, a kitchen)
7 DO NOT PLACE AN OBJECT ON TOP
Do NOT place an object on the unit.
7 DO NOT BLOCK VENTS
Do NOT use the player on top of a long-fibered carpet, bed or
sofa, and do not cover it with a cloth etc. This will prevent heat
radiation and could result in damage.
7 AVOID HEAT
Do NOT place the unit on equipment generating heat, such as an
amplifier.
When installing the unit in a rack, place it on the lowest shelf
possible (however, not where it is exposed to dust) and separated
from the amplifier to avoid the heat generated by the amplifier or
other audio equipment.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by
tugging the cord and never touch the power cord when your hands
are wet as this could cause a short circuit or electric shock. Do
not place the unit, a piece of furniture, etc., on the power cord, or
pinch the cord. Never make a knot in the cord or tie it with other
cords. The power cords should be routed in such a way that they
are not likely to be stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the power cord once
in a while. When you find it damaged, ask your nearest PIONEER
authorized service center or your dealer for a replacement.
Detailed
Operation