Filter
Top Products
Connecting up
02
17
En
Connecting using the component
video output
If your TV has component video inputs, you can
use these instead of the standard video output
to connect this system to your TV. This should
give you the best quality picture from the three
types of video output available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT to a set of component inputs
on your TV.
• The component video output is switchable
between interlaced and progressive
formats. See
Video Output settings
on
page 70 and
Watching progressive scan
video from the component video outputs
below for more on this.
Watching progressive scan video from
the component video outputs
Compared to interlace video, progressive scan
video effectively doubles the scanning rate of
the picture, resulting in a very stable, flicker-
free image. Progressive scan video is available
only from the component video output. There
are a few things to keep in mind when
switching the
Component Out
(page 70)
setting to
Progressive
:
• When set to
Progressive
, there is no video
output from the
VIDEO OUT
(composite)
and
S
(S-video) jacks.
• If you want to display video on more than
one monitor simultaneously, make sure
the player is set to
Interlace
.
Important
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the setting to
Progressive
, you will not be
able to see any picture at all. In this case,
press
STANDBY/ON
to put the system
in standby, then press and hold the front
panel
(stop) button for about 8 seconds
until the display shows
Mem.Clr.?
. Press
the front panel
or
button
so that the display shows
Interlace?
. Press
the front panel
button to set to
interlace and switch the system back on.
When TV format is set to
AUTO
or
NTSC
:
• When set to
Progressive
, PAL and NTSC
discs are both output as progressive NTSC
video. See also
TV format setting
on
page 75.
• When set to
Progressive
, there is no video
output from the
VIDEO
and
S-VIDEO
jacks. If you want to display video on more
than one monitor simultaneously, make
sure that it is set to
Interlace
. See also
TV
format setting
on page 75.
VIDEO
CONTROL
PR
PB Y
COMPONENT
VIDEO OUT
SUB
WOOFER
LR
FRONT
S-VIDEO
OUT
VIDEO
OUT
SPEAKERS
IN
TV
COMPONENT
INPUT
XV-DV9.book 17 ページ ２００４年２月２０日 金曜日 午前１１時４２分