Filter
Top Products
10
Handling the Display
• Set up your display on a stable,
level surface away from any direct
light or heat source, but near a
grounded AC outlet.
• Choose a well-ventilated location
with an adequate amount of space.
Do not block the vents on the back
of the display.
• Never lift the display by the desk
stand. Use both hands to lift or
move the display. Avoid touching
the screen.
• Never apply pressure to the screen
or touch the screen with bare ngers
or with any objects.
• Allow the display unit to reach room
temperature before powering on.
• Avoid sudden temperature changes
in the environment, as this may
cause condensation, which damages
the display.
• Never remove the back cover or
disassemble the display. There are
no user-serviceable parts inside.
• In locations where 240V outlets
are used, connect the Dome E2c
display only to a center-tapped,
240V, single-phase supply.
• When troubleshooting, check that
all cables are properly connected
and that your computer is turned
on and not in power-saving mode.
• Follow your local governing
ordinance for proper disposal or
recycling of electronic components.
020-0458-00A_3.indd 10020-0458-00A_3.indd 10 4/12/06 5:36:42 PM4/12/06 5:36:42 PM