Filter
Top Products
- 17 -
System Connections (Continued)
Connecting to TV Antenna
This unit can be connected to the TV signal input source via the TV jack on the rear panel.
After connection, turn on the power of the unit, press the SOURCE button of the remote or the unit
and select TV as the input mode.
After connecting to the antenna, you can turn on the unit. To select channels you can do the
following steps:
1. For channels 0 through 9:
Press the number buttons to select the channel, wait three seconds and it will go to the
selected channel.
Press the number button to select channel, then press the +10/
to go to the selected channel
immediately.
Press the number buttons to input 00X
, it will go to the selected channel immediately.
2. For channels 10 through 99:
Press the number buttons to select channel XX
, wait three seconds and it will go to the selected
channel.
Press the number buttons to select channel XX
, then press the +10/ button to enter the
selected channel.
Or press the number buttons to input 0XX
, it will go to the selected channel immediately.
3. For channels 100 through 100~199:
Press the number buttons to select channels XXX
, and it will go to the selected channel.
NOTE: * X is the channel number.