Filter
Top Products
4
14. Do not rest objects on the power cord and avoid placing the power cord near high traffic areas.
15. Do not overload wall outlets and extension cords because this can result in a risk of fire or electric
shock.
16. Disconnect your plasma TV from the main power supply and refer servicing to qualified service
personnel if:
• The power cord or plug is damaged or frayed.
• Liquid has been spilled into your plasma TV.
• Your plasma TV has been exposed to water or moisture.
• Your plasma TV does not operate normally when the operating instructions are followed. Adjust
only those controls that are covered by the operating instructions. Incorrect adjustment of other
controls may result in damage which often requires extensive work by a qualified technician to
restore your plasma TV to normal operation.
• Your plasma TV has been dropped or the cabinet has been damaged.
Avoid Image Sticking
1. Displaying the same stationary patterns over extended periods of time, such as letterbox black bars,
stock tickers, video games, or shopping channel logos and pricing displays, can leave an image
permanently burned into the screen. Avoid this by mixing your viewing patterns. Do not show the
same stationary image for more than 15% of your total TV viewing in any one week.
2. The warranty does NOT include PDP screen degradation.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Warning
To assure continued FCC compliance, the user must use grounded power supply cord and the provided shielded
video interface cable with bonded ferrite cores. If a BNC cable is going to be used, use only a shielded BNC (5)
cable. Also, any unauthorized changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this device.