Filter
Top Products
10
On the HP-48, press F (RECV).
( The HP48 is now "Connecting").
In kermit, type S INSTALL <cr>.
( The code will be sent to the HP-48
in 5 packets, and a beep will sound at
the end of transmission.)
In kermit, type Q <cr>. This returns
to DOS.
On the HP-48, press VAR .
The menu at the bottom of the screen
should now show
INSTA SP300 IOPAR
IOPAR has the baud rate, ect currently
used by the HP-48.
On the HP-48, press A ( INSTALL)
( This stores the library SP300LIB into
PORT 0: . The HP-48 will automatically
turn itself off at this time.)
On the HP-48, press ON .
On the HP-48, press RIGHTSHIFT
( green on the HP-48G) , then 2 .
( The menu at the bottom of the
screen should now show SP300
with a bar over the label indicating
a submenu.)
On the HP-48, press A ( SP300) .
The HP48 is now ready to connect
to a monochromator. The operating
instructions are included in the SP-300
manual.