Filter
Top Products
Name and function of each part
Remote Control Unit
4. REV/FWD-Scan buttons
Use these buttons to scan forward and
backward through pictures or sound.
8. ANGLE button
Press it to switch the picture's angle.
2. EJECT button
Press this button to slide the disc out and in.
3. NUMBER buttons
Press these buttons to input numbers.
5. TITLE button
Press this button to display the DVD's title.
7. ZOOM button
Zoom in or zoom out the picture on screen.
9. SLOW button
Press this button slow playback at 1/2 ,1/4,1/6 ,1/8speed.
11. Program button
Use this button to program individually.
1. SEARCH button
Locating a title/chapter/time and playing.
12. VOL-. button
Press this button to volume down.
SEARCH
1
PBC
2
3
4
5
6
7
8
9
0 10+
A-B
MUTE
TITLE
ZOOM
DVD
MENU
ENTER
SUBTITLE
SETUP
REPEAT
SLOW
ANGLE
RETURN
AUDIO
DISP
PROGRAM
MENU
AV/DVD
VOL- VOL+
POWER
EJECT PDVD
-
+
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
V I D E O
13. PBC button
Playback control.
15. Play/Pause button
Use this button to play picture or
sound or stop temporarily.
14.SD card buttons
Press this button to ON/OFF the SD card power
16. STOP button
Press this button to stop playback of the picture or sound
17.10+ button
Press this button to select a program of
which the sequence number on the disc is more than 10.
18 . A-B REPEAT button
Press it during playback to set Point A and Point B and then
the program between Point A and B can be played repeatedly.
6.MENU button
Press this button to display the DVD's
menu screen.
4
Connection Diagram
12
BATTERY
Video2 input( yellow)
Video output( yellow)
CAR AUDIO(DVD OR VCD)
Audio left input (white)
Audio left output (white)
Audio right input (red)
Audio right output (red)
Installation(Professional installation recommended)
1.Unpack and check the
contents.Disassemble the
meral support bracket from
the unit as shown in the
illustration,by unscr ewing
the six screws on the unit
body.
2.Tighten the metal support bracket
to the ceilling support beam(s),
using the supplied screws. Take
extra care to not penetr ate the
roof of your car.
3.Connect the wiring harness,
according to the diagram under
"Connection Diagram"on page19.
to the wires located in the dome
light of your vehicle.
4.Flip the monitor screen down and
tighten the monitor to the support
bracket, using the supplied screws.
17
IR wireless headphone(optional)