Filter
Top Products
Installation Guide HyperStack Cable 9000 Series Stackable Chassis Switch
Corporate Headquarters QLogic Corporation 26650 Aliso Viejo Parkway Aliso Viejo, CA 92656 949.389.6000 www.qlogic.com
International Offices UK | Ireland | Germany | France | India | Japan | China | Hong Kong | Singapore | Taiwan
Secure the HyperStack Cables
Secure the cables in place using ties wraps as
shown. Secure the outer cables to the rack
posts; secure the inner cables to each other. This
reduces cable clearance to 7–8 inches and
provides room for the removal of the Power
Supply and Fan blades on the lower switch.
1. Tie Wraps
Confirm HyperStack Operation
Confirm that the ICC port Logged-In LEDs on all
CPU blades are illuminated. This indicates that
the switches are communicating.
1. Logged-In LEDs
Enter the Show Interconnect command to
confirm each ICC port is online.
Switch #> show interconnect
Blade ID ICC ID State LSDB ID ISOREASON
-------- ------ ----- ------- ---------
CPU0 ICC0 Online 0x1000 NotApplicable
ICC1 Online 0x1001 NotApplicable
CPU1 ICC0 Online 0x1010 NotApplicable
ICC1 Online 0x1011 NotApplicable
Enter the Show Fabric
command to confirm that
both QLogic 9000 Series
switches are in the fabric.
Switch #> show fabric
Domain WWN Enet IP Addr FC IP Addr SymbolicName
------ --- ------------ ---------- ------------
*1 (0x01) 10:00:00:c0:dd:07:4a:e8 10.20.83.203 0.0.0.0 QLogic 9000
2 (0x02) 10:00:00:c0:dd:00:6a:2d 10.20.68.12 0.0.0.0 QLogic 9000
* indicates principal switch
1
1
1
© 2011 QLogic Corporation. Specifications are subject to change without notice. All rights reserved worldwide. QLogic, the QLogic logo, and HyperStack are trademarks or registered trade-
marks of QLogic Corporation. All other brand and product names are trademarks or registered trademarks of their respective owners. Information supplied by QLogic Corporation is believed to
be accurate and reliable. QLogic Corporation assumes no responsibility for any errors in this brochure. QLogic Corporation reserves the right, without notice, to make changes in product
design or specifications.