Filter
Top Products
9
Checking the Codes
If you have set up the remote using the
procedure in “Searching for a Code,” you
may want to know which ve-digit code is
operating your equipment.
1. On the remote control, press a device key
once (TV, CBL/SAT, DVD, VCR or AUD);
it blinks once. Then press and hold P until
the device key blinks twice.
2. Enter 9 9 0. The device key blinks twice.
3. To nd the rst digit of the code, press 1
once. Count the number of times the LED
blinks and write down the number.
If the LED blinks once, the rst digit is 1,
if it blinks twice, the rst digit is 2, etc. If
a code digit is 0, the selected device key
does not blink.
4. Repeat step 3 four more times for the
remaining digits, pressing 2 to nd the
second digit, 3 to nd the third digit, 4 to
nd the fourth digit, and 5 to nd the fth
digit. Write down the rest of the code and
keep it in a safe place.
Volume Lock
Your remote comes preset with the volume
locked to the TV mode. This conguration
allows you to control the volume of the TV
while in the CBL/SAT, DVD or VCR modes.
However, you may change the Volume Lock
setting to Global Volume Lock to a different
mode so that volume control is always
controlled through your audio receiver. After
that, you can perform Individual Volume
Unlock on a selected device to set its volume
control for independent operation.
Locking Volume Control to One Device
1. Press and hold P until the LED blinks
twice, then release.
2. Enter 9 9 3. The LED blinks twice.
3. Press the device key for the device you
wish to control volume (for example, TV).
The LED blinks twice.