Filter
Top Products
Troubleshooting 41
USER
’S GUIDE
Solution
Try the “Search Method”on page 12.
1. Try all the codes listed for your brand.
2. Try the “Search Method”on page 12.
See our website (www.radioshack.com) for help or
take your remote to your local RadioShack store.
You may be using the wrong code. Try repeating
the “Direct Code Set Up” procedure (page 10)
using another code listed for your brand, or start
the “Search Method”(page 12) over again to
locate the proper code.
Enter the channel number exactly as you would
on your original remote. If the original remote
control required Enter to be pressed to change
channels, press ENTER on the remote after
entering the channel number.
Due to RCA design from 1983 to 1987, only the
original remote control will operate these
functions.
As a safety feature on your remote, you must press
RECORD twice.
Make sure you are using new batteries and are
aiming the remote at your device.
Replace batteries with 4 new alkaline batteries.
Some products may need both a Tuner (or
Receiver) code and an Audio Amplifier code for
remote control of all features on your audio
device.
Make sure the satellite receiver can be operated
with an infrared (IR) remote control and is not set
up to receive only radio frequency (RF) signals.
RadioShack_Kameleon_v3b.qxd 4/10/03 3:22 PM Page 41