Filter
Top Products
45
Press to store your selection.
10. Repeatedly press or to select the
start hour. When the correct hour appears,
press . Then repeatedly press or
to select the minute and press .
11. Repeat Step 9 to set the stop time.
12. Repeatedly press or to select the
channel. Then press .
To record from a source connected to the
R-
AUDIO-L IN 1/VIDEO IN 1
or
AV2
jacks,
repeatedly press or until
LINE1
or
LINE2
appears. Then press .
13. Repeatedly press or to select a pre-
set program category that you see when
you view the program index —
DRAMA
,
MUSIC
,
COMEDY
,
MOVIE
,
SPORTS
, or
N/A
(not applicable). Then press .
14. Repeatedly press or to select the
tape speed (
SP
,
LP
, or
SLP
). Then press
.
15. Double-check all the set information.
• If the information is correct, press
PROG
.
• If an entry is not correct, repeatedly
press or
to move the cursor to
the incorrect entry, enter the correct
information, then press
PROG
.
The timer settings appear on the TV
screen. To enter another setting, repeat-
edly press or to select another timer
number and repeat Steps 7–13.
16. Press
PROG
again.
TURN
VCR
OFF
FOR
TIMER
RECORDING
briefly appears.
17. Press
POWER
to turn off the VCR. TIMER
appears.
Notes:
• Be sure that TIMER appears when you
turn the VCR off. If it does not appear,
check your entries.
• If you load a cassette with its erase-
protection tab removed and set the VCR’s
timer, the VCR ejects the cassette and
TIMER and flash. See “Playing a
Video Tape” on Page 28.
• If you set up the VCR to record a broadcast
through a cable box or direct-to-home sat-
ellite receiver, be sure to leave it turned on
and tuned to the desired station before the
broadcast starts.
• You can manually turn on and operate the
VCR before the set times, but the VCR
starts an automatic timer recording only if
the power is off at the set start time.
Monitoring an Automatic Timer
Recording
1. Turn on the TV and set it to the same chan-
nel as
3-CH-4
on the back of the VCR.
Note:
If you are using a TV/monitor that is
connected to the VCR’s
R-AUDIO-L/VIDEO
OUT
jacks, set the TV/monitor to its video
mode.
2. Press
TV/VCR
until VCR appears.
Checking/Changing Timers
1. Turn on the TV and set it to the same chan-
nel as
3-CH-4
on the back of the VCR.
Note:
If you are using a TV/monitor that is
connected to the VCR’s
R-AUDIO-L/VIDEO
OUT
jacks, set the TV/monitor to its video
mode.
2. Turn on the VCR and repeatedly press
TV/
VCR
until VCR appears.
3. Press
PROG
. You see the set program
menu.
16-635.fm Page 45 Wednesday, July 21, 1999 9:03 AM