Filter
Top Products
22
2. Programming The Ten Device Buttons
This will program ONE learned code onto the Device
button, so that when you select that Device, it will send out
the learned signal as it changes to that Device's function
pages.
1. Go to the SETUP mode by pressing both the MAIN and
ENT buttons simultaneously for three seconds.
2. Press the LEARN button next to the LCD screen.
3. Important: Press the PAGE button.
4. Place your original remote control head to head with the
MX-500
TM
about 2 inches apart on a flat surface.
5. Select any of the ten device buttons you wish to
program on the MX-500
TM
. Press the button on your
original remote control you wish to program into the
Device button you have chosen on the MX-500
TM
. Once the
MX-500
TM
has received the signal, the MX-500
TM
will flash
“Good” on the LCD screen, indicating it learned the code
correctly. If it flashes “Fail”, repeat from Step 4 until it
learns successfully. (Please enter the code signal within 20
seconds of programming.)
6. Return to Step #5 until you have programmed all of the
Device buttons that you require.
4. Programming the MX-500
TM
to Control Your Components