Filter
Top Products
26
6. Programming Macro Buttons
A “macro” is a series of commands that you choose to be
sent out with the push of one button.
There are two types of macro functions you can program
with the MX-500
TM
:
The M1, M2, M3, POWER and SYSTEM OFF buttons
are designed to send out up to twenty commands from each
of the five hard buttons. The ten device buttons can each
send a macro of up to 20 commands when the device
button is pressed for more than 1 second while on the
MAIN page of the remote control.
Important: If you program the POWER or SYSTEM OFF
buttons with a macro, they will no longer function as ON
and OFF buttons for your components. Just erase any
macros you have programmed on to these buttons if you
want to restore the original ON and OFF function.
See the “Tips” at the end of this section for help on
programming macros.
A. Programming Macro Functions To M1, M2, M3,
POWER And SYSTEM OFF Buttons
1. Go to the SETUP mode by pressing the MAIN and
ENTER button simultaneously for three seconds.
2. Press the MACRO button next to the LCD screen.