Filter
Top Products
6
Basic TV + VCR Connection
Helpful Hints
Your VCR may not have Audio and Video
Out jacks, but only an RF or ANTENNA
OUT jack.
Use a coaxial cable to connect the VCR’s
ANTENNA OUT jack to the TV’s 75 OHM
ANTENNA INPUT jack.
(ANTENNA
INPUT)
The basic component (VCR, DVD player etc.) to TV connection is described below. For other hookups, refer to your
component’s instruction manual.
Connect the audio cables (white and red) to the R and L AUDIO jacks on the TV and to the Audio output jacks on the
VCR (or other component). Match the cable color to the jack color.
If your component has Component Output Jacks (Y, Pb, Pr), connect three video grade cables to the Y, Pb, Pr
jacks on the component and to the Y, Pb, Pr jacks on the TV. If your component doesn’t have these jacks, go to
item 3.
If your component has an S-Video jack, connect an S-Video cable to the S-VIDEO jack on the TV to the S-Video jack
on the component. If your component doesn’t have an S-Video jack go to item 4.
Connect a video cable (yellow) to the VIDEO INPUT jack on the TV and to the VIDEO OUT jack on your VCR (or other
component).
Turn on the TV and the component.
Press the INPUT button on the remote control until the correct video input channel appears in the upper right corner of
the TV screen. When you play material on a VCR, DVD player, etc. it will appear on the TV on the video input channel.
(The bottom of page 4 has a complete list.)
Use either S-VIDEO jack or VIDEO INPUT
jacks. Do not use both at the same time
for the same piece of equipment. This
would interfere with the picture display. If
both are used, S-VIDEO has priority over
the yellow VIDEO INPUT jack.
Rear Panel Side AV (front)
Note: The position of
your jacks might differ.