4
5
English
3. Plug one end of the included USB to mini-USB cable
into the amplifier on the ANT1150F’s built-in cable.
4. Plug the other end of the included USB to mini-USB
cable into the power adapter provided.
Note: If your TV has a USB power outlet, you can plug the USB
to mini-USB cable directly into it for power instead of using
the power adapter. If you use a TV USB power outlet, you can
skip step 5.
5. Plug the power adapter’s power cord into an electrical
outlet.
Important: This power unit should be plugged in so that it stays
vertical or lies flat.
6. Scan for channels on your TV.
Note: You can bypass the amplifier on this antenna if you notice
that some channels are not coming in as consistently as you’d
expect. Simply unplug the power supply (see step 3). This bypasses
the amplifier.
To mount the antenna using the mounting strips:
1. Clean the surface of the location with isopropyl rubbing alcohol. Wipe gently, then let
the area dry.
Important: Do not use household cleaners.
2. While the area is drying, separate the mounting strips. Snap them apart length-wise first,
then snap each of the resulting strips in half.
3. Remove the red liner. Press the adhesive strip onto one of the top corners of the back of
the antenna. Repeat for the other top corner. Then place a single mounting strip on the
metal section in the bottom middle of the antenna, with the strip facing down.
Mounting the Antenna to the Wall
Once you’ve confirmed the best location for your antenna and scanned for channels, you’re
ready to mount the antenna to that location, using the mounting strips included. If you
decide to move the antenna after you’ve mounted it, no problem: the mounting strips
detach from the wall easily, without harming your wall’s surface, and are easily replaceable at
most retail and drug stores.
Caution: DO NOT use the mounting strips with wallpaper. The mounting strips may not adhere
well to vinyl surfaces. Apply to surfaces above 50°F (10°C). Adhesive could lose adhesion above
105°F (40°C).
Note: The antenna also has two holes along its top edge for hanging it using screws or tacks (not
included).
TV
In-Line Amplifer
ANT1150F
Built-In
Coaxial Cable
ANTENNA
TV/STB
4
5
3
2
6
1. Make sure your TV is turned off.
2. Connect the ANT1150F’s built-in cable to the antenna
input on your TV.
Important: Make sure you uncoil the antenna’s coaxial cable
completely. Leaving it coiled will reduce reception performance.
Connecting the ANT1150F to Your TV