RCA ANT3036X TV Antenna User Manual


  Open as PDF
of 12
 
Step 9: Install the transformer
Findthe10/32”hexnutsandwashersinyour
hardware bag.
Findthesmallelementsbetweenthereector
booms. These elements have posts at their
bases.
Place two washers on each post. Then position
the transformer leads between the two washers
as shown here.
Transformer
Post
Transformer
lead
Finally,tightenthehexnutstosecuretheleads.
Step 10: Insert end caps
Insert the plastic end caps in the ends of the
booms as shown here. Use a rubber mallet to
gentlytapthemintotheantennaboomsto
secure them.
Step 8: Attach the mast clamp insert
Find the U-bolt and mast clamp insert (see
the illustration to the left). Put the U-bolt
into the mast clamp insert with the teeth of
the mast clamp insert facing the closed end
of the U-bolt.
Insert the U-bolt into the mast clamp on
theantennaandlooselythreadthe1/4”
hexnutsontotheU-bolt.Theteethon
the mast clamp and the teeth on the insert
should be facing the same direction.
Donottightenthehexnutsyet.
Mast
clamp
U-bolt
Mast clamp insert
 previous next