Filter
Top Products
18 Chapter 2
Using the Remote Control
Graphics contained within this publication are for representation only.
Chapter 2 19
Using the Remote Control
Graphics contained within this publication are for representation only.
The Buttons on the Remote Control
(0-9) Number Buttons Enter channel numbers and time settings directly
through the remote control.
To enter a one-digit channel, enter a zero rst. To enter a two-digit channel,
press the two digits. To enter a three-digit channel, press and hold the 1 button
until 1 and two dashes (– –) appear, then add the second two digits. Example:
to tune to channel 123, press and hold 1 until 1– – appears, release the 1 button
and then press 2 and 3.
ANTENNA In VCR mode (if programmed), this button works as a TV/VCR
button for some VCRs. In SAT mode (if programmed), this button works as a
TV/SAT button for some satellite receivers.
Arrows Used to highlight different items in the TV menu and to adjust the
menu controls. The up and down arrows move the PIP window when no
menus are on the screen. When watching TV without the PIP window or
menu system in use, the left and right arrows (ZOOM– and ZOOM+) change
the current format of the screen (4:3, Zoom 14:9, Zoom 16:9, Zoom 16:9 ^/v,
Cinerama, regular mode 16:9).
AUX•HD Puts the remote in AUX/HD mode. As a default, this button controls
some models of RCA HDTV Tuners. It can also be programmed to operate
some brands of an additional remote-controllable components. The Autotuning
feature for this button works only with HDTV tuners (see page 24 for more
information on Autotuning).
CH + or CH - Scans up or down through the current channel list. Press once
to change the channel up or down; press and hold to continue changing
channels. In DVD mode (if programmed), these buttons work as chapter
advance or chapter reverse buttons with some DVD players.
CLEAR Removes any menu or display from the screen and returns you to
normal viewing. Also exits PIP or POP if no menu is displayed.
DVD Puts the remote in DVD mode and, if Autotuning is enabled, will turn on
the TV and tune to the correct input channel.
FREEZE When watching TV, freezes the picture until you press any button
on the remote to resume normal TV viewing. The FREEZE feature automatically
times out after a short time. Please note that when you "unfreeze" you go back
to live programming (skipping any programming that occurred during the
freeze).
Note: The FREEZE feature does not work on signals from the DVI-HDTV, CMP1
or CMP2 inputs in progressive scan (480p) or HDTV (1080i) modes.
Do not use the Freeze feature for an extended period of time. This can cause
the image to be permanently imprinted on the picture tube. Such damage is
not covered by your warranty. Press any button to unfreeze the picture at any
time.
GO BACK Returns you to the previous channel.
GUIDE Brings up the Channel Guide menu.
Indicator Indicates the programming mode when programming the remote
to control components. The indicator lights up when you press a valid button
on the remote. It ickers when the remote batteries are low and you press a
button.
Indicator
1
2
3
4
5
6
7
8
9
0