Filter
Top Products
Connections and Setup
7
Connection: DVD + TV + VCR
1. Connect the audio cables to the AUDIO OUT L (left – white) and R (right – red) jacks on
the back of your DVD player, and to the corresponding Audio Input jacks on your TV
(sometimes labeled AUDIO IN L and R).
2. Connect the video cable.
Basic video connection – Connect the video cable (yellow) to the VIDEO OUT jack on
the back of your DVD Player, and to the Video Input jack on your TV (sometimes labeled
VIDEO IN).
Note: If your TV has an S-Video jack, connect the S-Video cable (not provided) to the
S-VIDEO OUT jack on the back of your DVD Player and to the S-VIDEO jack on your TV.
– OR –
If your TV has component video jacks (Y,Pb, Pr), use video-grade cables (not provided) to connect the
TV to the DVD player’s COMPONENT VIDEO OUT (Y, Pb, Pr) jacks. It is essential to match the color
coded connectors with a compatible TV.If your TV or monitor has progressive scanning capability, you
need to turn the VIDEO SELECTION switch to the PROGRESSIVE SCAN ONLY position.
3. Connect the antenna or cable to the Antenna Input jack on the VCR (sometimes labeled IN
FROM ANTENNA).
Note: Connecting a VCR is optional. It is only shown in this diagram because most households have a VCR
connected to the TV.
4. Connect a coaxial cable to the Antenna Output jack on the VCR (OUT TO TV) and to the
Antenna Input jack (CABLE/ANTENNA) on the TV.
5. Insert the power cord into the unit and into an AC outlet.
6. If your TV is capable of using progressive scanning and you connected the DVD Player to the
TV by connecting the Component Video Jacks (Y, Pb, Pr), make sure you move the VIDEO
SELECTION switch to PROGRESSIVE SCAN ONLY position.All other connections should
leave the VIDEO SELECTION switch set to REGULAR CONNECTIONS (VIDEO, S-VIDEO,
COMPONENT)
Go to page 8