Filter
Top Products
53
Reference
Troubleshooting
Troubles sometimes are caused by simple “faults” that you can correct without the
help of a service technician. If you experience any difficulty with your TV, check a few
basic remedies before calling your service technician.
TV will not turn on
• Check to make sure it is plugged in.
• Check the wall receptacle (or extension cord) to make sure it is “live” by
plugging in something else.
• Maybe batteries in remote control are “dead.”
• Maybe remote control is not aimed at remote sensor.
• The front panel controls may be locked (disabled). Use the remote control to
unlock the front panel controls by selecting the Front Panel Block in the Parental
Controls menu and choosing Unblock.
Controls don’t work
• If using remote control, make sure remote is in TV mode by first pressing TV
button.
• The front panel MENU button may be disabled. Use the remote control to turn
off channel blocking. Select Channel Block in the Parental Controls menu and
choose Off.
• Try unplugging set for two minutes and then plug it back in and turn it on again.
Problems with remote
• Maybe something is between the remote and the remote sensor.
• Maybe the remote is not aimed directly at the component (TV or VCR) you are
trying to control.
• Maybe remote is not in TV Mode. Press the TV button so remote will control TV.
• Maybe batteries in remote are weak, dead or installed incorrectly. Try replacing
batteries. (Note, if you remove the batteries, you may have to reprogram the
remote to control other components.)
• Remove batteries and hold number 1 for at least 60 seconds to drain the
microprocessor inside the remote. Release number 1, replace the batteries, and
(if necessary) reprogram the remote.
Guide comes on when I turn on TV
• The Guide automatically comes up when you use the TV button on the remote to
turn on the TV. You can turn off this feature by selecting GUIDE Plus+ Menu from
the Main Menu, then select Setup, then select Options and then select Off.
Turns off while playing
• Schedule off function may have been activated.
• Electronic protection circuit may have been activated because of a power surge.
Wait 30 seconds and then turn on again. If this happens frequently, the voltage
in your house may be abnormally high or low.
• Unplug. Wait five minutes. Plug in again.