Filter
Top Products
4. INSTALLATION
Installationmenu helps you to setup a variety of
parameters necessary for receiving signal, add
new service, upgrade the new software and reset
the channel data.
Select Installationmenu in main menu, and you
will be asked to enter your PIN code.
You can find the following Installationscreen by
entering it.
MENU OPERATION 19
MENU OPERATION18
LNB Power
LNB Type
LNB Freq.
22KHz
Search option
DiSEqC 1.0
Motor
: Depending on the users antenna LNB, you can supply either LNB power by
setting ONor not by setting OFF. Normally set this to ON.
: You can select the LNB type.
: You can select the predefined LNB frequency or manually enter a specific
frequency in MHz unit by pressing numeric keys.
: In case you are using two antennas connected to a 22KHz tone switch box,
you can supply either 22KHz by setting ONor off by setting OFFto select
antenna.
: You can search all the free channels & scramble channels or only free channels
or onlyscramble channels by setting the search option.
: If you have DiSEqC box, you can choose port by selecting port number.
Otherwise, choose none
: If you have a DiSEqC 1.2 motorised system, then you can takeadvantage of the
DiSEqC 1.2 functions available. Choose Installer as Motor and press “F1” key.
After that, adjust antenna direction using browse keys.
4.A. ANTENNA SETUP
Your receiver includes the preprogrammed information of transponders contained in various
satellites.
You can update the transponder list preprogrammed
for a satellite by adding a new transponder to it or
modifying the information of the existing transponder.
(Refer to the Channel Scan described in section 4.B)
Select Antenna Setupmenu in Installationmenu
and the following screen will be displayed.
Select the desired satellite using the left/right
keys(
).Set LNB Power, LNB Type, LNB
Freq, 22KHz
”,Search Option, and DiSEqC 1.0
fields to the appropriate value using the left/right
keys(
) at each field.
4. A. 1 Automatic Scan
Check the signal strength. Press OKkey to start the scan procedure.You can see the
progressive status of channel searching.
Please note that the scan procedure may take a few minutes.
Press the menukey or exitkey to return to previous menu.
4. A. 2 Blind Scan
Blind Scan search the channel when you don’t know
the transponder information.
Press the F2 key to start the blind scan procedure
and the following screen will be displayed.
Please note that the scan procedure may take a few
minutes.
Press the “menu” key or “exit” key to return to
previous menu.