Filter
Top Products
MENU OPERATION 21
MENU OPERATION20
4. B. 1 Channel Scan
Select the desired satellite using the left/rightkeys ().
Select the Antenna Configurationicon using the browse keys(
).
Press OKkey, and set LNB Power, LNB
TypeLNB Freq, 22KHz, Search Option, and
DiSEqC 1.0fields to the appropriate value using
the left/rightkeys(
) at each field. Check the
signal strength and press Exitkey.
Select the Search/Edit TPicon using the left/right
keys(
). Press OKkey, and select the
desiredtransponder using the up/downkeys (
). Press OKkey to start the manual searching for
selected transponder.
Freq.
S/R
PoI.
FEC
: Input the frequency of the transponder you want to find manually.
: Inputs the symbol rate of the transponder you want to find.
: Select the polarization of the transponder you want to find. In the case of
horizontal,18V and in the case vertical, 13V are output through LNB line.
:
Select the FEC of the transponder you want to find. You can select the value of 1/2,
2/3, 3/4, 5/6, 7/8 or auto.
4. B. 2 ADD SATELLITE
You can add a new satellite. Select the Add Satelliteicon using the left/rightkeys (
),
and press the OKkey.
Select the Search/Edit TPicon using the left/rightkey
(). Press the OKkey and add
a new transponder using the F1key. You should set various parameters of the transponder.
The default name of the added satellites is UserSAT-No.
4. B. 3 RENAME SATELLITE
You can also change the satellite name. Select the Rename Satelliteicon using the left/right
keys (
).
Press OKkey and select the character which you want to edit using the browse
keys (
,). Press the OKkey to confirm. Save the character currently renamed using
the F2key.
4. B. 4 DELETE SATELLITE
You can also delete the user satellite. Select the satellite that you want to delete from the satellite list.
Select the Delete Satelliteicon using the browse keys (
,).
Press the OKkey, and the selected satellite will disappear.
You can see the progressive status of channel searching.
If you cannot find the desired transponder from the transponder list, you can add it by inputting
appropriate parameter values for a new transponder using the F1key. When you want to
change the parameter of an existent transponder, select the parameter using the F1key,
change its value and press the ExitKey.Correctly set various parameters.
4. B. CHANNEL SCAN
It will be more convenient to use Channel
Scan
procedure when you want to search
channel for a specified transponder offered from the satellite. As in Antenna Setup,
Channel
Scan
also searches all channels broadcasted over a specific transponder
using its predefined information. You can add a new transponder if you cannot find it on
the predefined transponder list.
Select Channel
Scan
menu in Installationmenu, and the following screen will be
displayed.
4. A. 3 USALS
-Please go to Antenna Setup and select USALS
from motor.
-Press F1 then Pop-up will be appeared.
-Press arrow button to write Longitude
-Press arrow button to write Latitude, then OK to
work.