Filter
Top Products
4
6. Place the opened
arms over the back
of your display. Adjust
the arms along the
length of the tilt
adjustment rod so
that they line up with
the mounting holes
on back of your
display. The hinges on
the arms should be
located towards the
bottom of the display
(see Fig.10).
Fig.7
1
2
3
Fig.8 Fig.9
Fig.10
5. Remove the clips located towards the top of each
arm and take out the pins (see Fig.8). Then push
down and hold both tilt adjustment rod knobs
simultaneously. Lift both sides of the rod together
and open both arms completely as shown in Fig.9.
For displays with
curved or
recessed backs.
For displays
with flat backs.
Fig.11
7. Attach the mount arms to the back of your display
using the screws identifi ed in Steps 1 and 2 (see
Fig.11):
A. If you are using the M6 screws you will also
need to use the M6 washers (H). M8 screws do
not require washers.
B. If you are using the longer screws on a display
with a curved or recessed back, you will also
need to use the spacers (I). Use one spacer or
two spacers stacked as needed. You should
only use a spacer if necessary.
1
2
Fig.12
8. Close the mount arms by returning them to the
original position. Insert the pin and replace the
clip on both arms (see Fig.12). Make sure the tilt
adjustment rod is turned to the locked position
by rotating the knobs away from the display. The
mount arms must be fully closed and locked
before moving on to the next part.