Filter
Top Products
(BLINK)
(BLINK)
Programming With Code Search
1. Turn on the device you wish
to program.
2. Press and hold CODE SEARCH
until the INDICATOR LIGHT
lights, then release CODE
SEARCH.
3. Press and release the device
button for the device you are
programming (TV, VCR or
CABLE). The INDICATOR
LIGHT will blink once then
remain lit.
Note: For AUX, press SAT•AUX then
the device button you are
assigning to AUX.
4. Press and release ON•OFF until
your device turns off.
Important: You may have to press
ON•OFF up to 200 times.
5. When your device turns off,
press the ENTER button, the
INDICATOR LIGHT will go off.
If your TV, VCR, or Cable Box does not respond after you have
tried all the codes for your brand, or if your brand is not listed, try
searching for your code by following the steps below.
Retrieving Codes
1. Press and hold CODE SEARCH
until the INDICATOR LIGHT
lights, then release CODE
SEARCH.
2. Press and release the device
button for the device’s code
you are retrieving (TV, VCR or
CABLE). The INDICATOR
LIGHT will blink once then
remain lit.
3. Press and release CODE
SEARCH. The INDICATOR
LIGHT will blink, then stay on.
4. Starting with 0 on the keypad,
press the number buttons in
order (0-9) until the
INDICATOR LIGHT blinks.
5. The number which causes the
INDICATOR LIGHT to blink is
the first digit of your code.
6. Repeat step 4 until you have
retrieved all three numbers in
the code. The light will now
go out.
If you need to find the three-digit code for your TV, VCR or
Cable Box after your device is set-up using Code Search, use
this procedure.
…
(OFF)
INDICATOR
LIGHT
The Menu is used to make changes such
as setting color, channels, timers, etc.
Entering the Menu Mode:
1. Push the DEVICE button on the
remote.
2. Push the MENU button.
This puts the remote in Menu Mode.
The Menu should now be visible on
the television. The INDICATOR LIGHT
will blink continuously to indicate the
remote is now in Menu Mode.
While in MENU these buttons will
function as follows:
VOL UP/DOWN buttons will
operate as CURSOR RIGHT/LEFT.
CH+/- keys will operate as CURSOR
UP/DOWN.
For RCA, GE an ProScan, pushing the
MENU button will select the highlighted
item. The numeric buttons may also be
used to select the MENU choice.
Note: Not all functions in competitive models and
brands of televisions may be fully supported.
Exiting the Menu Mode:
To exit the Menu Mode and clear the
screen push the DEVICE button on the
remote. The INDICATOR LIGHT
should go out indicating the remote is
now out of Menu Mode and will
revert to it’s normal mode of
operation.
Note: The remote will automatically exit the
Menu Mode after 10 seconds of inactivity
with no buttons being pushed.
Special notes:
1.Because of the wide variety of menu
formats, some experimenting may be
required.
2.SONY: Pressing the ENTER button while
in menu mode returns to
previous menu.
3.ZENITH: Push the menu button a
second time to move from
the SET-UP MENU to the
VIDEO MENU.
(BLINK)
Menu Functions
13
CODE
SEARCH
CODE
SEARCH
14
(BLINK)
(BLINK)
INDICATOR
LIGHT
CODE
SEARCH
RCU410MSL_IB 10/4/01 1:57 PM Page 14