Filter
Top Products
9
Setting Up the VCR
Startup
10. Add or remove channels from the VCR’s memory.
You may want to add or remove channels if some of the channels
are not active, have weak signals, or you do not want to watch
them.
A. Press VCR1 on the remote.
B. Press MENU•PROG on the remote to see the VCR MAIN MENU
on the TV screen.
C. Press 3 to display the CHANNELS menu.
D. Press 2 to display the ADD/REMOVE CHANNELS menu.
E. Follow the directions on the screen.
F. Add or remove more channels by entering channel numbers or
using the CHAN up or down on the remote or CHANNEL up or
down on the VCR.
continued on next page
9. Place channels in the VCR’s memory.
Channels 2 through 13 including line inputs (L1 and L2) are in the
VCRÕs memory when you first turn it on. The VCR stops on these
channels when you press CHAN up or down on the remote or
CHANNEL up or down on the VCR. To get additional channels
available on your antenna or cable system, you must use the Auto
Channel Search feature of the VCR. If you ever change cable or
antenna signals, you may need to auto channel search again. See Cable
Box Setup on page 23.
A. Press VCR1 to set remote to control VCR.
B. Press MENU•PROG on the remote to see the VCR MAIN MENU on
the TV screen.
If the menu does not appear on the TV screen:
¥ Press VCR1 and then press MENU•PROG.
¥ If you have used one of the basic hookups, make sure the TV is
tuned to the same channel (3 or 4) as the Output Channel
selected in the PREFERENCES menu.
Check VCR indicator in display panel Ñ it should be on. Press
TV•VCR to turn it on.
¥ If you have connected your VCR using one of the advanced
hookups, tune your TV to its video input (refer to TV OwnerÕs
manual).
¥ Check the connections.
C. Press 3 to select CHANNELS.
D. Press 1 to begin Auto Channel Search.
Wait until the channel numbers stop changing. The TV will then
tune to the lowest channel found. Press CHAN up or down on the
remote or CHANNEL up or down on the VCR to select the active
channels.
The VCR automatically selects ANTENNA or CABLE for the Signal
Type feature in the CHANNELS menu. If you need to change the
setting manually, press 3.
VCR MAIN MENU
1 Timer Recordings
2 Set Clock
3 Channels
CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
3 Signal Type: CABLE
4 Cable Box Setup
0 Exit
VCR MAIN MENU
1 Timer Recordings
2 Set Clock
3 Channels
CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
ADD/REMOVE CHANNELS
CH 03
is presently ADDED
Press CLEAR to remove
Press MENU to exit