Filter
Top Products
FPI FireGenie
TM
Remote Control Manual18
TROUBLESHOOTING
If the Remote Control does not turn on:
• Check to see that the Receiver is in the “Remote” position.
• Ensure the batteries are correctly installed in the Receiver.
• Check the batteries for replacement.
When batteries are replaced, only the current time and day will need to be reset. The set program times
are not affected.
Battery Replacement
The Remote Control takes 2 x AAA alkaline batteries.
To replace simply remove the Cover from the back of the Remote Control, take out the old
batteries and replace with new ones.
The Receiver takes 4 x AA alkaline batteries.
To replace, simply remove the Spring Loaded Battery pack from the Receiver by pushing in
and then pulling out. Then remove the Cover from the top of the Receiver, take out the old
batteries and replace with new ones.
IMPORTANT NOTE
When there is no signal from the Remote Control to the Receiver
either when the battery is low or the remote is out of range, the unit
will automatically shut down in 4 hours +/- 48 minutes.