Filter
Top Products
ShenZhen BeiJing Optoelectronics Science & Technology Co.,LTD
深 圳 市 贝 晶 光 电 科 技 有 限 公 司
深 圳 市 贝 晶 光 电 科 技 有 限 公 司深 圳 市 贝 晶 光 电 科 技 有 限 公 司
深 圳 市 贝 晶 光 电 科 技 有 限 公 司
Page 6 Total 7 Pages
Connection for Reference：
：：
：
Installation：
：：
：
1.
The distance between controller and power supply or between LED modules and
controller should be no more than 3 meters;
2.
When choosing the power cord, please remember that the total current of the LED
modules connected with the power cord should not exceed the normal working current of the
power cord;
3.
Please make sure that the metal case of the power supply is connected with the ground
line since the power supply must be grounding;
4.
The waterproof and insulating treatment should be done for the last module of each
loop;
5.
The controller and power supply must work in the ventilated and dry environment;
6.
The Grey output wire(V) of the controller should be connected with the grey common
anode wire(DC12V) of the controlled modules, while another three output wires of red, green and
blue should be connected with the red, green and blue wires of the controlled modules;
7.
Please confirm that no short circuit exists between input or output wires of the main line
of the controlling. If electrified when short circuit existing, the internal components may be
burned out;
8.
When doing the connection and installation, please take care and don’t disassemble or
install without switching off the power;
9.
If the controller working out of the way, please don’t disassemble or removing privately,
but contact with the manufacturer to solve the problems.