Roland TU-70 Universal Remote User Manual


 
10
Return of
pulled-out material
Material feed
Take-up of fed material
The CJ/FJ stops
operation
Take-up of
fed material
MOTOR ERROR
TURN OFF POWER
6. Operating Conditions for the TU
The TU takes up material fed from the CJ/FJ. Performing an operation to pull out material from the CJ/FJ generates corresponding force,
and so the CJ/FJ displays the error message, and operation stops. When performing printing in particular, such a stop in operation may
affect the printing extremely, such as misalignment of the printing location.
*Material can not be taken up with TU when CJ performs cutting. TU can be used only when printing.
OK NO GOOD
CJ/FJCJ/FJ
TUTU
When using the TU, make the settings for the following conditions.
For Both the CJ and the FJ
At the display menu, set [AUTO SHEET CUT] to [DISABLE].
Do not use the [SHEET CUT] key to separate the material.
Do not use the
or keys to return the material.
For the CJ Only
Turn off the cutting function on the program you're using.
From the display menu, set [PREFEED] to [DISABLE].
From the display menu, select something other than [ROLL] for the material.
Do not perform automatic detection of the base point or align point when loading
material.
When loading material, use the right-hand grit roller (to ensure that the material overhangs the TU sensor area).
For the FJ Only
Load the material so that it is close to the right-hand side (to ensure that the material overhangs the TU sensor area).